[blaster99]

Here are the directions that I used to put a tether on my ds.

1. If the contact is closed when the tether cored is removed, connect the contact in parallel with the key switch wires. The black, and black and yellow (if there is no black and yellow, there should be a black and white wire. This will give a ground to the ecm when removed, and will stop the engine without shutting down the ecm.
2. If the contact is open when the tether cord is removed, disconnect from the left switch housing, the black and white wire and connect the cord between. This will remove power from the engine and shut the ecm down.


Im not sure how to find out if your tether is closed or open, but I'm sure if you called the manufacturer, they would tell you.