Thread: PC5 maps
View Single Post
  #11 (permalink)  
Old 07-20-2010, 09:37 AM
TNT TNT is offline
Senior Member
 
Join Date: Dec 2008
Posts: 903
View TNT's Photo Gallery(0)
Quote: Originally Posted by JeffO View Post
Quote: Originally Posted by ds450power View Post
from what i've read about auto tune on the raptor forums is after u auto tune u can view how + or - it made to ur map at all the rpms and throttle %
Was thinking there was something like that. I read some other topic somewhere where people would borrow an auto-tune, get it tuned, then give it back. I just want to see how far off my map is that I am using now (when I get the auto-tune shortly)
From what I understand about autotune is no matter what tracks you run, no matter what the load on the motor or atomoshpere, the map will be adjusted to it, a power map 14.7:1……. I don’t think that means adjust to baseline maps. The “open” loop no autotune stock system will adjust +/- to the baseline MAP within it's capability, say 30%....Its usually rich since there is no O2 input, fuel drowns out oxy before exiting exhaust. An autotuner closes the loop, reads EGT and O2 to remap or send voltage to the injector to +/- fuel. If the engine is running lean for example, all fuel is burned, and the extra oxygen leaves the cylinder and flows into the exhaust. In this case, the sensor voltage goes lower. Remove it the O2 then the input is loss, open loop takes over runs rich again.

Last edited by TNT; 07-20-2010 at 06:45 PM.
Reply With Quote