|
Most are normally open & then close when pulled
If you don't have a meter, you can use a light tester or even a battery & bulb of equal volts. putting the tether in line between battery pos + & light then ground or negative (-)
If the light glows it is closed if not it is open, pull tether & light & switch should change state.
NO ONE LIKES A TETHER that cuts out on the track so.....
Also good to solder & heat shrink connections or at least use good sealed connectors & a good crimp tool. then tape or cold shrink the connections. I can send some to anyone if they needs them.
|