torque specs

DAVIDPKORUS · #1 (**permalink**) 02-05-2011, 02:01 PM

I know I know buy a service manual, any got the torque # for clutch cover the one around the clutch and the one that covers the clutch

TNT · #2 (**permalink**) 02-05-2011, 04:09 PM

Manual just calls for loctite on the screws and l-shaped area at the top to the gasket and motor...where the gasket gets kind wide, no torque values. Blue locktite on clutch release cover gasket and screws too, no torque values.

Side note: Didn't you just get a MW's new FMI, tell me how it connects, what wires. what connections to the ECM, injector, TPS???

DAVIDPKORUS · #3 (**permalink**) 02-05-2011, 06:09 PM

u plug it into the grey wire conecter for the fuel injecter then the conecter that u disconect plugs into another conecter coming from the fmi and then just ground it... so theres 2 connecters coming from the fmi and a groun wire... trying not to be too confusing

TNT · #4 (**permalink**) 02-05-2011, 09:55 PM

Good deal thanks. Forget the line(s) going to the injector and ground can you tell me where the other line is going or give me some wire colors to the connector? I'm thinking TPS or ECM? BTW don't over torque those screws they got LT.