over heating problem solved

fast rap · #11 (**permalink**) 01-02-2010, 11:46 PM

Quote: Originally Posted by CANAMracerdad

We were told by Simon from Can-AM to buy the Cv-4 Hoses, drilll the rad / tank area with 1/2" holes and glue in chicken wire. We were also told to change the thermostat. the limp mode was removed for overheat , and the mapp was modified.

dose anyone have pics of this mod just want to see exactly where there drilling the holes.

pawel · #12 (**permalink**) 01-03-2010, 11:05 AM

check here:
Project DS450 MX: Prep for Racing in Advanced Classes - If you want to run with the Pros, get out the wrench and the checkbook - ATV at Off-Road.com

canamdan · #13 (**permalink**) 09-11-2010, 10:24 AM

Can the inline cooler be used for the stock hoses and where does it go?

azirish · #14 (**permalink**) 09-11-2010, 10:56 AM

yes it can dan, it goes lower left side of bike, the hose there, either the horizontal area or the vertical area after the bend

azirish · #15 (**permalink**) 09-11-2010, 10:58 AM

look at my avatar picture in my photos, blow it up and you can see just behind the shock where i put mine, the cooler is so big you cannot miss it

over heating problem solved

better radiator

can am ds 450 radiator hoses

can-am ds 450 radiator hoses

gas tank over heating problem can am

heating

honda 450x heating problem

in-line cooler

inline cooler

inline raditor cooler for 08 can am ds 450x

install inline cooler

louvers

louvers under motorcycle cooler

over heat

polaris ranger 800 eps overheating

polaris ranger heat problem

pro billet cooler install can am ds 450x

problem with heat from radiator on driver on polaris ranger

rad mod

radiator hoses

thermostat