my ds wont start

[lovetodune]

today i started puttin a tether cord on my ds for racing so i turning on my quad then touched the ground to the radiator and the main black wire of the tether to the coil to kill it, it did kill the quad but when i tried turning it on again it wouldnt start because of limp mode any one no why this happened? my mods are a full ron woods race core exhuast and the pink wire for the engine,, someone tell me what to do to get it off limp because every time i put the key in to try and start it today it says its in limp, the temp isnt causing this because its cool in my garage also the battery is good because it cranks over everytime but if i keep cranking it the crank gets weaker and weaker could it be the battery? please help me out on this it was workin fine until i killed it with the tether

[fast rap]

check your fuse's sounds like one burn out, and there is a few good threads on here how to hook it up properly. most have been going to the
bk,bk/w wires on the ignition switch on 08's!!!!

[lovetodune]

Quote: Originally Posted by fast rap

check your fuse's sounds like one burn out, and there is a few good threads on here how to hook it up properly. most have been going to the
bk,bk/w wires on the ignition switch on 08's!!!!

thanks a lot fast rap i looked on the forum and found that another fuse box was on the left motor mount and it was a blown fuse got it replaced and fired right up thanks again

[DiRtDevilz1]

Just make sure it's wired right. I made a sticky on it awhile back in important information. Don't want to blow any fuses before a race bro.