Can-Am DS-450 Forum :: DS450HQ.com banner
1 - 2 of 2 Posts

·
Registered
Joined
·
548 Posts
Discussion Starter · #1 ·
What has anyone done to block off the vent hole on the hood of these things? I noticed that's what a lot of XC guys are doing and was going to try and replicate myself, with a piece of thin aluminum. When I had the plastic off the other day, it appeared that there were two small screws on the underside, in that vicinity, that I could use to secure, along with some silicone to seal the area off, on the underside.

I suppose a few exposed pop rivets wouldn't look too amateur would they???

Thoughts?
 

Attachments

1 - 2 of 2 Posts
Top